|
|
Search results for "articulated vacuum cup holders" Vuototecnica
|
Basic articulated vacuum cup holders
The technical and mechanical features are the same as for the basic vacuum cup holders. Their distinctive feature is their articulated joint in hardened steel, which allows the flat cups installed on these cup holders to adapt themselves to the loads to be lifted with slightly tilted surfaces, as well as to compensate possible verticality errors that can arise between the cup holder and the automation fixing support.
The actual springing stroke is:
- For height C= 28 mm 16 mm
- For height C= 65 mm 49 mm
- For height C= 95 mm 74 mm
Product codes: 026520 028520 0211020 0211022
|
|
|
|
Special articulated vacuum cup holders
The distinctive feature of these cup holders is their articulated joint in hardened steel, which allows the flat cups installed on these cup holders to adapt themselves to the loads to be lifted even if not completely parallel with the cup plane, as well as to compensate possible verticality errors that can arise between the cup holder and the automation fixing support.
Their technical and mechanical features are the same as the other previously described special vacuum cup holders.
The actual springing stroke is:
- For height C= 55 mm 37 mm
- For height C= 110 mm 84 mm
Product codes: 0611012 0611017 0615012 0615017 0620012 0625012 0622012OF 0622012NF 0622012A 0630012 0635012
|
|
|
|
Special articulated vacuum cup holders with compact stroke
Marble and glass sheets are usually handled with cups that take them from a horizontal plane and place them vertically or vice-versa.
These special cup holders with compact stroke have been designed to minimise the lever forces between the cup and the automation fixing bush during the rotation of the sheets, as well as their sliding on the cups. They share all the technical features of the other previously described special cup holders but their overall dimensions are reduced to minimum by housing the articulated joint in the cup support, thus reducing the steel stem and the spring stroke length and modifying the brass bush, in order to allow it to be screwed directly onto the automation. Moreover, a special non-slip plastic coating fixed onto the cup support prevents the lifted load from slipping.
The actual springing stroke is:
- For height C= 29 mm 13 mm
Product codes: 0611042 0612742 0615042
|
|
|
|
Special articulated vacuum cup holders with double springing
The distinctive feature of these cup holders is their articulated joint in hardened steel, which allows the flat cups installed on these cup holders to adapt themselves to the loads to be lifted even if not completely parallel with the cup plane, as well as to compensate possible verticality errors that can arise between the cup holder and the automation fixing support.
The cup holder fixing bush is located between two springs: the lower one cushions the impact of the cup with the load to be lifted during the approach phase, while the upper one cushions the impact of the bush with the cup holder end and gradually loads the cup during the lifting phase.
These cup holders are especially recommended when the load to be lifted is very heavy, rough or not perfectly flat.
The actual springing stroke is:
- For height C= 55 mm 37 mm
- For height C= 110 mm 84 mm
Product codes: 0611014 0611018 0615014 0615019 0620014 0625014 0622014OF 0622014NF 0622014A 0630014 0635014
|
|
|
|
Special articulated vacuum cup holders without GS articulated joint
Unlike the ones previously described, these special articulated vacuum cup holders have an articulated joint housed in the cup support. This has allowed a reduction of the overall dimensions without affecting performance.
The actual springing stroke is:
- For height C= 55 mm 37 mm
- For height C= 110 mm 84 mm
Product codes: 0611032 0615032
|
|
|
|
